General

Topic	Replies	Views	Activity
Where to learn Sheetcam I am real new and need pictures and videos, any help appreciated. I have biult an JDs DIY PlasmaCNC. Got it working and I want to learn Sheetcam.	5	1263	March 14, 2025
Welcome to Sheetcam! :wave:	0	430	May 19, 2024
About the General category	0	52	May 19, 2024
PP access to Operation variables in the var. table	1	4	July 31, 2025
Transverse Position Error Exceeded	0	3	July 31, 2025
How would I make this part in sheetcam	1	15	July 27, 2025
How do I disable layers in Operations window and simulation?	1	12	July 21, 2025
Post processor for sf2300 controller	1	12	July 21, 2025
Post Processor for 3 heads (drill, engrave, plasma)	1	14	July 21, 2025
Sheetcam scribe	4	28	July 14, 2025
I need help, My computer got damaged and I lost My software with my license inside	1	22	July 11, 2025
Lost my table in sheetcam	1	20	July 9, 2025
Hugong InteCut postprocessor	2	29	June 28, 2025
Is V7.1.40 downloadable for Linux?	12	201	June 17, 2025
SafeZ remove and X Y C seperate movement	3	29	June 12, 2025
Problems with arcs	7	86	June 11, 2025
Using rules for THC On/OFF on STV Optimum	3	48	June 11, 2025
Overcut does not work	1	33	June 4, 2025
Postprozessor for Vanad Mira 20/30 with B&R Software	2	43	June 4, 2025
Postprocessor documentation	1	60	May 30, 2025
Eastwood Plasma Cutter	11	100	May 26, 2025
Drag knife - free software version question	3	49	May 4, 2025
Post Processor for plasma with ohmic probe and THC	1	50	May 1, 2025
Don’t want to waste $$ on redundant systems	6	132	April 22, 2025
Need Sheetcam post for Baileigh PT-44	0	28	April 18, 2025
X & Y Axis travel is wrong way	2	24	April 10, 2025
Layers don't show up in sheetCam	1	34	April 10, 2025
Raise torch at end of cut program?	4	62	April 9, 2025
Installing sheetcam on ubuntu 18.04.06	1	34	March 30, 2025
Post Processor runs, but file only 1kb	2	30	March 27, 2025