Confessions of a Sheetcam Face Plant

That’s a reasonable suggestion. I’m already on their forum (as bLouChip) and I’m aware of CNCNutz expertise, in fact he is the publisher of the following info…

I just browsed Masso’s forum for ‘sheetcam’ and found quite a bit of recent traffic in the past 30 days. CNCNutz is involved. They reference a Sheetcam post processor named ‘MASSO G3 Plasma with Scribe v2.1.scpost’. After further searching their site, I found the scpost here, https://forums.masso.com.au/threads/sheetcam-plasma-post-processor-for-version-5-software-with-rule-and-scribe-support.2673/
along with copious usage instruction (which I have not fully read yet) and several updates to the original scpost info, so please read the entire referenced thread.

I then compared this scpost with apparent previous versions that are shipped with Sheetcam, and this v2.1 seems much improved in terms of function and ease of use. It does support the DTHC.

Please advise if help is still needed after all of these instructions have been read, digested, and applied.