Page 1 of 1
Scriber settings
Posted: Thu Mar 09, 2017 4:34 pm
by machinist 1 on
How are you Les , i am running Candcnc's commandcnc and i was wondering if you could help me set up my scribe so the cylinder would stay down and the scribe stay on the entire scribe cycle and only the z axis move up and down .This is how Wolfsmetalfab has his set up and seems to work the best that I have seen. He has a video on Yootube if you would like to view for a better explanation of the process,thanks for your time.
Posted: Thu Mar 09, 2017 4:46 pm
by Les Newell
What post processor are you using?
Scriber settins
Posted: Thu Mar 09, 2017 5:22 pm
by machinist 1 on
CandCNCPlasmallcnc-23(Edited)
Scriber settings
Posted: Thu Mar 09, 2017 5:25 pm
by machinist 1 on
CandCNCPlasmaLLCNC-rev23(Edited)
Posted: Thu Mar 09, 2017 6:13 pm
by Les Newell
I don't have that post. Could you send me a copy.
Posted: Thu Mar 09, 2017 6:25 pm
by machinist 1 on
Here you go Les ,thanks
Posted: Thu Mar 09, 2017 6:48 pm
by Les Newell
Give this a try. I hate messing with CandCNC posts. They are very complicated and it is difficult to make changes and be sure you aren't affecting some other part of the code.
Scriber settings
Posted: Thu Mar 09, 2017 6:52 pm
by machinist 1 on
Sure will , i will let you know how it goes , thanks
Scriber settings
Posted: Thu Mar 09, 2017 7:35 pm
by machinist 1 on
I just tried it Les and it doesn't seem to be adding the offsets to the code