New machine set up.
I can use MDI in Mach and the machine goes in correct directions. Neg X goes left of zero. Positive X goes to the right…
This machne has the home or zero, zero set at bottom right instead of bottom left.
With that said, when I run the attached tap file the x movement goes oppisite to what it should go. Neg X is going to the right of zero.
G code shows neg X numbers…
I’m missing something big time. I need a hint or a glass of wine. Maybe both.
Thanks, Aj
I don’t see an attached file, but when you do Sheetcam, where is the
origin located in your drawing???
Art
country bubba
At 06:57 PM 2/7/2013, you wrote:
New machine set up.
I can use MDI in Mach and the machine goes in correct directions.
Neg X goes left of zero. Positive X goes to the right…This machne has the home or zero, zero set at bottom right instead
of bottom left.With that said, when I run the attached tap file the x movement goes
oppisite to what it should go. Neg X is going to the right of zero.G code shows neg X numbers…
I’m missing something big time. I need a hint or a glass of wine. Maybe both.
Thanks, Aj
Art, what’s up with the 6 replys of the same e-mail?
The file is to the bottom right of the original post.
Just click on “download”
As for the origin location in the drawing, that has never been a problem.
Aj
Not sure why there were 6 reply’s. I view the posts on this forum in my email client and rarely log in like I have this time. We will see how many replies it sends this time.
As for the origin, I was referring to the origin in the drawing not the tap file. This can make the table move in the wrong direction if you have the X origin on the right hand side of the drawing.
Art
My web host has been having some problems recently. They were subjected to a DDOS attack and it appears to have messed a few things up. I guess that could have caused the multiple posts.
AJ, I looked at your cose and it looks correct to me.
If you enter G0X0Y0 does it move to the bottom right corner?
Now enter G0X-5. It should move to the left.