Tap file not converting dxf properly .

Problems and questions
1

Hi I’m new here at the forum . Move recently bought sheet cam after sometimes struggling to load files into my techserve plasma.
I use fusion360 for drawing. I was advised to buy sheet cam to help smooth the process .

I can import the drawing into sheet cam and everything looks good in terms of correct colours . Run the post process and get the tap file . But when I load into the plasma , it just comes out with horrible wavey lines and looks nothing like the part . Am I doing something wrong in the process ?

2

Could you post a picture of the wavy lines.

3

Hi sorry late reply, I spoke with tech serve and they helped me with the issue . It was a code problem with the plasma table. Thanks again .