When I try to add a drill operation for my DXF file - Sheetcam picks up all of the holes except for 1. Any ideas?
Maybe it’s not a closed path?
the hole was created using Fusion circle tool. All of the other holes were created the exact same way
Thanks for sending us the support.zip file.
After review of the job file, your Drill Operation had boarder line tolerance on the max hole size to recognize for the operation on layer Holes. The large holes are 5mm in diameter, and your max size was also 5mm. I’m surprised more were not qualified/recognized for the for the operation. I changed the min to 4mm and the max to 6mm and all holes were qualified for the operation as expected.
I suspect you know that you have drawn very small, 0.025mm dia. holes at the center of the 5mm holes, but they don’t factor into any toolpaths being cut.