Pierce Delay on second cut

[Mike7]

Torch control g-code: need deactivated torch to activate and deactivate automatically

@Mike7 , I’ll add that normally the post flow air is intended to cool the torch tip so consider that aspect before making the change. based on your controller, you should be using ‘GRBL plasma.scpost’ or ‘GRBL plasma no Z.scpost’. In either case, if you desire to ‘double trigger’ the torch at end of cut, then make this change to the post processor… in OnPenUP() function… change: function OnPenUp() post.Text (“M5\n”) to: function OnPenUp() post.Text (“M5\nM3 S1000\nM5\nM3 S1000\nM5\n”) …