Page 1 of 1
Sheetcam 6.0.23 and Mach 3
Posted: Sat Apr 08, 2017 7:37 am
by plsmatech
Everything working fine unil cutting circles Sheetcam simulator running fine and then running tap file in Mach 3
Seems like Mach 3 is not recodnizing some of the code
Will add postproceesor file and tap file
Help
Plsmatech
See photos
Posted: Sun Apr 09, 2017 6:44 am
by plsmatech
Please see photographs
Posted: Sun Apr 09, 2017 2:49 pm
by WyoGreen
I'd try changing your Sheetcam job. First, I'd move the outside circle to it's own layer. Then I'd set up an operation to cut the layer the 5 inside holes are on as an inside offset cut. Next I'd set up an operation to cut the layer the outside circle is on as an outside offset cut. I think that will clear up the problem you are having.
Steve
Posted: Mon Apr 10, 2017 11:00 am
by plsmatech
Thanks Steve but it was a Post Processor Problem
Old post not compatible with new Sheetcam TNG