Page 1 of 1
Sheetcam in mach3
Posted: Wed Mar 13, 2013 8:34 pm
by bf4cm28
I can not figure out to add sheetcam into the dropdown menu from Mach3 or how to automatically get my g-gode to go to mach3?
Posted: Thu Mar 14, 2013 10:56 am
by Les Newell
This is due to a problem with the Mach installer. The only solution I have found so far is to install an early version of Mach then install the latest version on top of it (don't uninstall the old version).
Posted: Thu Mar 14, 2013 12:57 pm
by bf4cm28
Thanks!