Sheetcam in mach3

Having problems with or questions about SheetCam? Post them here.
Post Reply
bf4cm28

Sheetcam in mach3

Post by bf4cm28 »

I can not figure out to add sheetcam into the dropdown menu from Mach3 or how to automatically get my g-gode to go to mach3?
Top
User avatar
Les Newell
Site Admin
Posts: 3665
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

This is due to a problem with the Mach installer. The only solution I have found so far is to install an early version of Mach then install the latest version on top of it (don't uninstall the old version).
Top
bf4cm28

Post by bf4cm28 »

Thanks!
Top
Post Reply

Return to “Problems and questions”