modifying post processor for drilling
Posted: Thu Mar 28, 2024 2:18 pm
I have a premier plasma, i ran a simulation to see what the gcode looks like if i ran a drilling operation, but in the gcode i can still see the command "Z-100" for the floating head ,
can i change that setting in sheetcam, or do i delete that line from the post processor? i want to clamp a spring loaded center punch into my torch holder, so i can use the table to mark out holes for me to drill out on the drill press
i tried deleting the lines from the post processor, here's my 2 gcode files, which is a bunch of "holes " in a straight line left to right
one file is with the stock premier plasma post, adn one is with the modified post,
i'm a noob to gcode so does this gcode look like it would "drill" a hole with no problem? thanks
can i change that setting in sheetcam, or do i delete that line from the post processor? i want to clamp a spring loaded center punch into my torch holder, so i can use the table to mark out holes for me to drill out on the drill press
i tried deleting the lines from the post processor, here's my 2 gcode files, which is a bunch of "holes " in a straight line left to right
one file is with the stock premier plasma post, adn one is with the modified post,
i'm a noob to gcode so does this gcode look like it would "drill" a hole with no problem? thanks