sheetcam.com

Posted: **Fri Feb 23, 2024 2:19 pm**

Hello

After I've used Sheetcam what software should I use before exporting to a BURNEY 2.5 ?
As far as I can tell it needs.... *.nc

Posted: **Wed Feb 28, 2024 12:41 pm**

Sorry for the delay in answering but you should not need any extra software. In SheetCam go to Options->machine->post processor and select the burny25 post processor. Next change the 'Output file extension' setting to nc instead of tap.

sheetcam.com

First correct answer wins....

First correct answer wins....

Re: First correct answer wins....