Postprocessor for Snapmaker
Posted: Thu May 18, 2023 3:27 pm
Hi SheetCam User,
After good working with the postprocessor for Mach 3, I need for my Snapmaker a postprocessor. Mach 3 PP is no choice baecause the Snapmaker needs some more Code,I will attache the Snapmaker PP for ArtCam resp. Carveco. Maybe some one can help me. I am not able to correct the fault.
Here the message. So I understand that the PP from SheetCam are completly different than the PP fromArtCam.
Thank youu for helping me.
Christoph
After good working with the postprocessor for Mach 3, I need for my Snapmaker a postprocessor. Mach 3 PP is no choice baecause the Snapmaker needs some more Code,I will attache the Snapmaker PP for ArtCam resp. Carveco. Maybe some one can help me. I am not able to correct the fault.
Here the message. So I understand that the PP from SheetCam are completly different than the PP fromArtCam.
Thank youu for helping me.
Christoph