Trayectory problems
Trayectory problems
Hello.
The trajectories of the simulation do not follow the cutting profile of the drawing.
Debug: version 7.1.32
Assert failure in function wxCSConv::wxCSConv (C:\wx-3.0\wxWidgets\src\common\strconv.cpp:2870). invalid encoding value in wxCSConv ctor ("Assert failure")
I have inviate an email with support file.
With a simulator the generated gcode seems ok, but I'm afraid to send it to work.
It only does this when using the manually interrupt nested drawings function.
Thanks
The trajectories of the simulation do not follow the cutting profile of the drawing.
Debug: version 7.1.32
Assert failure in function wxCSConv::wxCSConv (C:\wx-3.0\wxWidgets\src\common\strconv.cpp:2870). invalid encoding value in wxCSConv ctor ("Assert failure")
I have inviate an email with support file.
With a simulator the generated gcode seems ok, but I'm afraid to send it to work.
It only does this when using the manually interrupt nested drawings function.
Thanks
Re: Trayectory problems
Sorry, wrong section
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: Trayectory problems
Do you have simulation set to the correct machine type? In simulation click on the setup button and check the machine type is correct. For instance if you are plasma cutting it should be set to 'Jet'.
Re: Trayectory problems
It's set to jet, but the problem persists.
Re: Trayectory problems
I tried to do the single step simulation and it's fine.
Re: Trayectory problems
Another problem I encountered is inside the support zip file the gcode that it inserts is not the one I'm simulating, but a previous one from a previous job.
Re: Trayectory problems
The simulation in the car is ok... I try to cut it?
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: Trayectory problems
I'm a bit late but if it simulates correctly it should cut correctly.
Re: Trayectory problems
No, it doesn't simulate correctly but it cuts correctly.
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: Trayectory problems
Did you email me the support file? I did not receive it.
Re: Trayectory problems
Yes, 2 email with a file support. At sales@ ... and problems@forum...
Re: Trayectory problems
I resent another email with everything at sales@sheetcam.com.
- Les Newell
- Site Admin
- Posts: 3673
- Joined: Thu May 11, 2006 8:12 pm
Re: Trayectory problems
That one got through. I ran simulation on your job file and the tool followed the path exactly. What exactly does it do when you run simulation?