Add overcut in tools??

[DynMetalworks]

I understand there is an "Overcut" setting in the Operations, but I would like a Overcut setting for each tool. This will let me set overcut lengths for different tools and not have to remember to input them in the Ops. Would I add this by modifying the post?

[djreiswig]

I don't think this is something you can do in the post. I think the overcut is an internal function inside SheetCam. Possibly it could be changed to a tool setting like the leads were a while back.

[DynMetalworks]

Yes, that would be nice if that could be apart of the next update. Thanks for the reply.