Problem with Plasma Cutting of Square and Rectangular Tubes (Seetcam Rotary+Mach3)

Having problems with or questions about SheetCam? Post them here.
Post Reply
yurapak
Posts: 8
Joined: Fri Dec 17, 2021 8:29 am

Problem with Plasma Cutting of Square and Rectangular Tubes (Seetcam Rotary+Mach3)

Post by yurapak »

Large melting (very large cutting width) of the metal on the edges (square, rectangular pipe), due to the low speed of the cutter.

Cutting flat sections and round pipes is no problem.

Maybe there are special settings in SheetCAM, Mach3.
Top
Post Reply

Return to “Problems and questions”