Sheetcam for two Seperate Machines
Posted: Thu Jun 09, 2022 3:21 pm
Good Morning. I currently have Sheetcam installed on my office computer which is a Windows Operating System and use the Post Processor for Mach 3.
I do all of my drawing in My office and just take a thumb drive to the Table. I'm buying an additional table with a Linux Computer that uses Command CNC. My question is, am I able to use the same Sheetcam for two different Post Processors? I assume the Sheetcam I have downloaded on My Windows Computer will work with the Linux? Thanks in advance.
I do all of my drawing in My office and just take a thumb drive to the Table. I'm buying an additional table with a Linux Computer that uses Command CNC. My question is, am I able to use the same Sheetcam for two different Post Processors? I assume the Sheetcam I have downloaded on My Windows Computer will work with the Linux? Thanks in advance.