Scananything camera orientation correction?

[nurbie]

I couldn't calibrate my camera until it was flipped 180 on Z.
Following this, it calibrated on first attempt.

Is there still a software analysis component you were working on? detection/correction of camera orientation based on motion analysis?
Obviously, it much easier to just flip the camera in meat-space...

More curiosity than need.

[robertspark]

I had the same problem when I tried scanything years ago.... again it was a head scratching moment....

then I just put a line on the camera to mark "up" for next time

[Les Newell]

Is this on Linux or Windows? The Linux version should auto detect an 180 degree rotated camera. Both versions detect small rotational errors and compensate for them

[nurbie]

I had to flip the camera to get things to work (LINUX xbuntu)

NOW, I just put 30 minutes into trying to just calibrate, but after homing in CommandCNC 2x Scananything will not load up control/stays grayed out.

Image is good, log tracks when I plug/unplug it.

Again, no machine section activating.

I have tried both Remote /simulation modes.
My remote is showing: localhost

I haven't changed anything on the machine since the app worked last time.

Of course, now a guy wants a part . . .

SCANANY_FAIL.png (225.82 KiB) Viewed 642 times