Post processor for HiCON controller?
-
- Posts: 11
- Joined: Sun Nov 13, 2016 12:00 am
Post processor for HiCON controller?
I'm looking at getting a Vital Systems HiCON 7866 controller with ArcPro THC. It appears Vital Systems does not have a post processor setup. Is anyone else here using this controller and if so, what post are you using?
-
- Posts: 257
- Joined: Thu Feb 26, 2015 12:11 am
Re: Post processor for HiCON controller?
it's not the controller but the CNC software that runs the controller that is important.
so look for a mach4 post processor if that is what CNC software you are running
so look for a mach4 post processor if that is what CNC software you are running
-
- Posts: 11
- Joined: Sun Nov 13, 2016 12:00 am
Re: Post processor for HiCON controller?
Alright thanksrobertspark wrote: ↑Wed Dec 08, 2021 8:20 am it's not the controller but the CNC software that runs the controller that is important.
so look for a mach4 post processor if that is what CNC software you are running