sheetcam.com

Plasma cutting on my rotary works perfect including ohmic touch off, but when marking my rotary's B Axis and X Axis begin to move before my Z axis (marker) touches the material. So about an inch of writing is missed on every new start point. I'm using mach3 and output is through parallel port and a break out board. All plasma z moves are done at around 60 inches a minute when cutting but when it's marking it seems that it's plunging at around 10 inches a minute. So it misses about an inch of writing. Everything would work if B and X axis waited till Z axis was done with it's move.
Thanks

Post is:
PlasmaRotary Mach3

Post settings:
RefDistance =75
RefFeed = 500
SwitchOffset = 0.0
ScriberX = 0
ScriberY = -34
ScriberZ = 0
ScriberAxis = "Z"
RefHome = false
RotaryAxis = "B"
UnitsPerRev=360
OptimiseRapids = 1
MaxRotation = 6