Page 1 of 1
Sheetcam
Posted: Sat May 22, 2021 9:58 pm
by ELMO
I have upgraded to sheetcam TNG V7.0.13 is this correct or do I need to use sheetcam TNG Development V7.0.14 ? Still having a problem. Won’t accept dxf followed everything I can read I am pretty sure all settings are correct. Thanks
Re: Sheetcam
Posted: Sat May 22, 2021 10:43 pm
by REMfg
we went with 7.1.14
Re: Sheetcam
Posted: Sat May 22, 2021 11:46 pm
by FabLab
Both versions should accept a dxf, if you a willing to upload your dxf I would be happy to take a look & see if I can help..
Re: Sheetcam
Posted: Sun May 23, 2021 1:52 am
by ELMO
Thank you for getting back to me. I will have to get someone to help send the file. I have had sheetcam for over a year. It worked fine
till bought the thc with firecontrol. Done all downloads and upgrades now it wont accept dxf. Just dont understand a lot about computers.
Re: Sheetcam
Posted: Mon May 24, 2021 12:04 pm
by Les Newell
When you import a drawing, is the file type set to 'DXF files'? In windows the file type is usually just above the open and cancel buttons in teh file selector box.