Page 1 of 1
Rapid moves through part when cutting tabs
Posted: Tue May 11, 2021 8:51 pm
by LongRat
- image_2021-05-11_214904.png (19.51 KiB) Viewed 428 times
Ver 7.0.13, when cutting a tab which is on a curved surface, rather than an arc move to follow the part contour I am getting a couple of linear rapids which collide with the part.
Re: Rapid moves through part when cutting tabs
Posted: Wed May 12, 2021 10:46 am
by Les Newell
It will do rapid moves if the tab thickness takes the cut above the rapid clearance height. Either raise the rapid clearance height or reduce the tab thickness.
Re: Rapid moves through part when cutting tabs
Posted: Wed Jun 09, 2021 10:08 pm
by LongRat
Thanks for the response Les.