Hi,
This may seem to be a silly question but I do not understand these two error messages I am getting.
1 " IJ mode is incremental"
and 2 "Axis not refd to normal condition"
I would be greatful for any information on how to solve these two problems?
Many thanks for any assistance.
Regards
Roy
Error Messages Not Understood
- Les Newell
- Site Admin
- Posts: 3671
- Joined: Thu May 11, 2006 8:12 pm
Re: Error Messages Not Understood
What controller are you using? " IJ mode is incremental" sounds correct. Most SheetCam posts use increemental I,J.