Page 1 of 1
Part import date?
Posted: Mon Mar 08, 2021 7:32 pm
by SeanP
I guess you have more than enough on just now! but while I remember would this be a possibility for the future?
Quite a few few times I find it would be really useful to know when a part was added to a job file, maybe there is already a way?
Thanks
- Sheetcam part import date.jpg (35.32 KiB) Viewed 5431 times
Re: Part import date?
Posted: Mon Mar 08, 2021 8:42 pm
by Les Newell
That's a good idea. I'll put it on the to-do list.
Re: Part import date?
Posted: Tue Mar 09, 2021 6:45 am
by SeanP
Good stuff, thanks Les
Re: Part import date?
Posted: Tue Mar 09, 2021 12:53 pm
by Les Newell
It will be in the next dev release.
Re: Part import date?
Posted: Tue Mar 09, 2021 7:54 pm
by SeanP
Superb
I have many sheets/jobs on the go there has been quite a few times when it would have been good to have the date when the part was added, yes I could have added it to the filename but already have plenty there ie, SP 10mm P2 qty 5.dxf , that will be a better way, thanks again.