Scananything - Manually draw and Distortion
Posted: Tue Nov 24, 2020 9:06 pm
Hello
Thx for these sweet software. Started using sheetcam for a old burny 2.5 controller, works like a charm!
We have talked a long time here about scanning scrap sheet metal parts. It is a common issue that we have odd looking parts laying around, hard to nest parts onto it.
Scananything is cool and all, but it seems like it is only aimed for 2 controllers and not an all around solution.
So basically my imaginary workflow would be:
*Calibrate and measure camera lens distortion.
*Mount camera over cutting table.
*Take picture
*Undistort
*Draw simple 2d outline of the sheet
*Enter known lengths
*Export to DXF
Does anyone know of a similar software that does this?
Thx for these sweet software. Started using sheetcam for a old burny 2.5 controller, works like a charm!
We have talked a long time here about scanning scrap sheet metal parts. It is a common issue that we have odd looking parts laying around, hard to nest parts onto it.
Scananything is cool and all, but it seems like it is only aimed for 2 controllers and not an all around solution.
So basically my imaginary workflow would be:
*Calibrate and measure camera lens distortion.
*Mount camera over cutting table.
*Take picture
*Undistort
*Draw simple 2d outline of the sheet
*Enter known lengths
*Export to DXF
Does anyone know of a similar software that does this?