Selecting the correct post processor

Having problems with or questions about SheetCam? Post them here.
Post Reply
plasmacut85
Posts: 1
Joined: Wed Jul 22, 2020 10:05 am

Selecting the correct post processor

Post by plasmacut85 » Wed Jul 22, 2020 10:40 am

Hello,

I am looking for advice on which post processor I should be selecting under the tabs, machine>post processor. I am running an STV CNC Plasma table that uses My Plasm CNC. More info on the controller can be found here https://www.proma-elektronika.com/myplasm-cnc-system/

Thanks in advance!

Post Reply