Selecting a suitable post processor

Having problems with or questions about SheetCam? Post them here.
Post Reply
Posts: 1
Joined: Fri Jun 19, 2020 5:15 pm

Selecting a suitable post processor

Post by Cliff » Fri Jun 19, 2020 5:35 pm

Hi all I am new to sheetcam I have built a plasma table using Universal g code sender and GRBL 1.1 I am having problems getting the relay that starts my torch to activate. What will be the best post processor to select

User avatar
Les Newell
Site Admin
Posts: 2563
Joined: Thu May 11, 2006 8:12 pm

Re: Selecting a suitable post processor

Post by Les Newell » Mon Jun 22, 2020 4:10 pm

Here are a couple of posts that may work for you.
To install a post, save the attachment to any convenient folder on your computer then run SheetCam and go to Options->machine->post processor. Click on the 'Import post' button. Using the box that appears, navigate to your post and open it. Go back to Options->machine->post processor and make sure your post is selected.
GRBL plasma no Z.scpost
(3.05 KiB) Downloaded 1 time
GRBL plasma.scpost
(3.04 KiB) Downloaded 1 time

Post Reply