Scanything

Having problems with or questions about SheetCam? Post them here.
Post Reply
TReimer
Posts: 1
Joined: Tue Jun 16, 2020 3:15 pm

Scanything

Post by TReimer » Tue Jun 16, 2020 3:21 pm

Hello,

i´m trying to calibrate my camera.
The manual movement is working perfect, but if i start the calibration, it found the first circle and overshoots the next time.
The orientation should be okay.

What could be the problem?
I haven´t bought a licence yet, i would first trying this, is it a problem?

best regards,
Thomas Reimer

robertspark
Posts: 155
Joined: Thu Feb 26, 2015 12:11 am
Location: nr Liverpool, England

Re: Scanything

Post by robertspark » Tue Jun 16, 2020 7:37 pm

I struggled on the orientation on mine and rotated the camera 180 degrees and it worked for me (I'm guessing it's the mirror reflection of the image.... right appearing on the left and left appearing on the right maybe)
Rob

WyoGreen
Posts: 221
Joined: Wed May 07, 2014 10:02 pm

Re: Scanything

Post by WyoGreen » Thu Jun 18, 2020 1:08 am

I think rob's right on his diagnosis. When I played with this a long time back, that was the problem I had. After rotating the camera 180 degrees, everything worked fine.

Steve

Post Reply