Wiggle pierce help.
Posted: Thu May 28, 2020 6:16 pm
After reading another post dealing with wiggle pierce, I thought it was about time I took another look.
I'm using candcnc 11J post with switch touch off, if I use no wiggle it's fine.
When I use wiggle as screenshot below it touches off raises to pierce height, then down to cut height briefly turns off torch,,,then lifts back up to rapid clearance height and then proceeds to start wiggle pierce and carries on as normal from there on.
Can anyone see what I am doing wrong, it looks a great feature that would benefit me as I cut sheets n sheets of 12mm with a 45a !
Thankyou
I'm using candcnc 11J post with switch touch off, if I use no wiggle it's fine.
When I use wiggle as screenshot below it touches off raises to pierce height, then down to cut height briefly turns off torch,,,then lifts back up to rapid clearance height and then proceeds to start wiggle pierce and carries on as normal from there on.
Can anyone see what I am doing wrong, it looks a great feature that would benefit me as I cut sheets n sheets of 12mm with a 45a !
Thankyou