Suddenly G03
Posted: Wed May 06, 2020 3:06 pm
All of my earlier cuts have square corners but suddenly all my corners have a G03 command and cut in arc moves.
Have I inadvertently enabled a function I'm not aware of? In the "Operations" I see there is something called
Loop Sharp Corners but it is set to 0 and None is checked below it.
Any ideas?
Tom
Have I inadvertently enabled a function I'm not aware of? In the "Operations" I see there is something called
Loop Sharp Corners but it is set to 0 and None is checked below it.
Any ideas?
Tom