Process item heading
Posted: Thu Apr 30, 2020 10:49 pm
I am not sure if this is already available or not as I have not been able to find it.
Recently a new feature was introduced to Universal Gcode Sender, and that was to use the "send from here" feature in case a problem developed in doing a process. I actually asked for the feature to be added and found that several others in the past had also asked for that feature, and now it is available.
While using it for plasma cutting, which is my concern, I found that there was a need to add something in the gcode generated by SheetCam that would make it easier to find where to start from here for the failed process.
I think it would be possible, if not already available, to use the post processor file to generate a heading for each process so that it would be easier to locate in the gcode file. I am not sure how to go about this myself, so I thought I may ask here if that is possible or already available.
Recently a new feature was introduced to Universal Gcode Sender, and that was to use the "send from here" feature in case a problem developed in doing a process. I actually asked for the feature to be added and found that several others in the past had also asked for that feature, and now it is available.
While using it for plasma cutting, which is my concern, I found that there was a need to add something in the gcode generated by SheetCam that would make it easier to find where to start from here for the failed process.
I think it would be possible, if not already available, to use the post processor file to generate a heading for each process so that it would be easier to locate in the gcode file. I am not sure how to go about this myself, so I thought I may ask here if that is possible or already available.