Outside Cut Lead In

Having problems with or questions about SheetCam? Post them here.
Post Reply
Hellsbellsidaho
Posts: 2
Joined: Sun Nov 03, 2019 9:57 pm

Outside Cut Lead In

Post by Hellsbellsidaho » Sun Nov 03, 2019 10:02 pm

I have been trying to process the attached with the work being an inside cut other than the O's middle which is an outside cut. But the lead-in on the center of the O is leading from inside instead of outside. I grouped the outside and inside using Autocad grouping. Any thoughts on the issue?
Attachments
Sheetcam Operations.PNG
Sheetcam Operations.PNG (25.75 KiB) Viewed 130 times
Lead In Issue.PNG
Lead In Issue.PNG (176.14 KiB) Viewed 130 times

User avatar
Les Newell
Site Admin
Posts: 2334
Joined: Thu May 11, 2006 8:12 pm

Re: Outside Cut Lead In

Post by Les Newell » Mon Nov 04, 2019 12:13 pm

That's odd. Could you attach the job file (File->save job) with everything set up so I can take a look.
For this application I'd recommend putting everything on one layer and doing an inside offset. SheetCam will automatically detect the inside of the O needs to be cut on the other side. It will also cut the inside first.

Post Reply