Page 2 of 2
Re: Post Processor for Flashcut Version 8
Posted: Mon Sep 09, 2019 5:54 pm
by camdenlake
Les i think your right on as usual
. Ok i figured out what i did wrong... Nothing to see here
. Will try testing this as soon as i get time.
Thanks again Les and Fabricator99
Re: Post Processor for Flashcut Version 8
Posted: Sun Feb 09, 2020 7:07 pm
by camdenlake
Just trying sheetcam with flashcut have not had time for a bit to play. I am getting a line 6 error opening the gcode. Invalid line parameter. Tried changing the machine name to the same as what i find under ID in flashcut but same error. Let me know if you have seen this or know what might be going on Les. Thank you again.
Josh