Having problems with or questions about SheetCam? Post them here.
3 posts • Page 1 of 1
We are having trouble cutting an accurate 2" circle. We suspect something in SheetCam. We are opening an accurate 2" circle dxf file, creating a tap file in SheetCam, loading it into Mach3 and our cuts are consistently as the attached pictures. We have calibrated and re-calibrated our machine and can cut a very accurate 2"x3" rectangle. Is anyone aware of any settings in sheetcam that may contribute to our dilemma or should we be looking elseware? It appears to be at the transition from positive motion to negative motion on the Y axis.
- 5833573321.jpg (529.43 KiB) Viewed 75 times