Kerf Width, is it available to the post processor / code snippets?

Having problems with or questions about SheetCam? Post them here.
Post Reply
robertspark
Posts: 257
Joined: Thu Feb 26, 2015 12:11 am

Kerf Width, is it available to the post processor / code snippets?

Post by robertspark »

As per the title: Kerf Width, is it available to the post processor / code snippets?

say I want to do something via a path rule (before end), is it possible to enter a variable in the distance such as kerf width?

Or is it possible to use a mathermatical expression such as kerf width + leadout?

Thanks,

Rob
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Kerf Width, is it available to the post processor / code snippets?

Post by Les Newell »

Kerf width isn't available to path rules. It is available to the post processor as the variable 'toolDia' but that means you need to edit the post processor to use the variable.
robertspark
Posts: 257
Joined: Thu Feb 26, 2015 12:11 am

Re: Kerf Width, is it available to the post processor / code snippets?

Post by robertspark »

Thanks,

That'll probably do that its available for the post processor.
Post Reply