Crash when Zooming in and using Actions points

Having problems with or questions about SheetCam? Post them here.
Post Reply
Cncburn
Posts: 13
Joined: Wed Apr 17, 2019 6:38 pm
Location: Land O Lakes, Fl. USA

Crash when Zooming in and using Actions points

Post by Cncburn » Fri Jul 05, 2019 11:28 pm

V6.0.3,Windows 7: I seem to get a consistent Crash if I zoom in very tight on a job, and try to edit the action points. Any suggestions? At this point, I can usually work around the Issue by not zooming too closely. The problem is that sometimes I want to get the Action point start or finish exactly in the right spot, and I need to drill in tightly to see it. Thanks for the help. 8)

Post Reply