Issue importing Sheetcam Windows job file to Sheetcam Linux
Posted: Fri Jun 21, 2019 4:33 pm
I've had this pop up before, but thought it was a drawing issue. It's popping up again today, and I know it's not a drawing issue. My file in Sheetcam Windows looks fine:
When I save that as a .job file, transfer to Linux, and open job in Sheetcam Linux, it looks like this:
Notice the holes, which are now incomplete. It seems like arcs are where I notice this.
I would understand this more if I was importing a drawing (svg, dxf, etc), but I'm not sure why the change in the geometry as a job file. Any ideas? I have confirmed that my Drawing Import settings are the same in both version (though messing with them doesn't seem to change anything).
If I post in Windows and open in CommandCNC, it's fine. If I post from Linux and open in CommandCNC, it shows the same defect (which I expected).
Windows Dev version 6.1.53, Linux 6.1.57
It has all 4 nodes of the holes, and will display an outside offset just fine. No offset or inside offset are boogered up, though.
When I save that as a .job file, transfer to Linux, and open job in Sheetcam Linux, it looks like this:
Notice the holes, which are now incomplete. It seems like arcs are where I notice this.
I would understand this more if I was importing a drawing (svg, dxf, etc), but I'm not sure why the change in the geometry as a job file. Any ideas? I have confirmed that my Drawing Import settings are the same in both version (though messing with them doesn't seem to change anything).
If I post in Windows and open in CommandCNC, it's fine. If I post from Linux and open in CommandCNC, it shows the same defect (which I expected).
Windows Dev version 6.1.53, Linux 6.1.57
It has all 4 nodes of the holes, and will display an outside offset just fine. No offset or inside offset are boogered up, though.