Scanything and Pokeys

Having problems with or questions about SheetCam? Post them here.
Post Reply
mariusl
Posts: 26
Joined: Wed Jul 27, 2011 2:56 pm

Scanything and Pokeys

Post by mariusl » Sun May 12, 2019 8:56 am

Hi
I am using Scanything with Mach3 and PokeysCnc57. I am having problems when trying to jog in the X axis. It would seem that I can only travel in one direction and only the master(not slave) motor is turning. All movement on the X axis is always in one direction no matter the direction of the request.
Any suggestions please?

Post Reply