Problem SheetCam TNG Development

Having problems with or questions about SheetCam? Post them here.
Post Reply
luis lopez
Posts: 16
Joined: Sun Nov 24, 2013 12:44 am

Problem SheetCam TNG Development

Post by luis lopez » Wed Apr 10, 2019 6:53 pm

Hola
Me ha surgido este error la importar un DXF al SheetCam TNG Development me ha convertido estas lineas en curvas
Como lo puedo solucionar ?

Hello
I got this error when importing a DXF to the SheetCam TNG Development has turned these lines into curves
How can I solve it ?
Attachments
Corte campana.dxf
(11.39 KiB) Downloaded 1 time
2.PNG
2.PNG (21.79 KiB) Viewed 69 times
1.PNG
1.PNG (16.55 KiB) Viewed 69 times

luis lopez
Posts: 16
Joined: Sun Nov 24, 2013 12:44 am

Re: Problem SheetCam TNG Development

Post by luis lopez » Wed Apr 10, 2019 6:54 pm

Este es el trabajo en SheetCam TNG Development
Attachments
Corte campana.job
(16.71 KiB) Not downloaded yet

User avatar
Les Newell
Site Admin
Posts: 2136
Joined: Thu May 11, 2006 8:12 pm

Re: Problem SheetCam TNG Development

Post by Les Newell » Wed Apr 10, 2019 7:23 pm

This looks like a detail reduction issue. Go to Options->application options->drawing import and reduce the arc fitting tolerance. Now reload your drawing. If you still have problems, reduce the arc fitting tolerance further.

luis lopez
Posts: 16
Joined: Sun Nov 24, 2013 12:44 am

Re: Problem SheetCam TNG Development

Post by luis lopez » Thu Apr 11, 2019 7:31 am

Gracias Les por su respuesta pero ya lo había probado pero no funciona debe ser algún problema de SheetCam TNG Development porque si lo abres en SheetCam TNG no da ese error.
Thank you Les for your answer but I had already tried it but it does not work it should be some problem of SheetCam TNG Development because if you open it in SheetCam TNG does not give that error.
Attachments
2.PNG
2.PNG (68.31 KiB) Viewed 52 times
1.PNG
1.PNG (58.76 KiB) Viewed 52 times

User avatar
Les Newell
Site Admin
Posts: 2136
Joined: Thu May 11, 2006 8:12 pm

Re: Problem SheetCam TNG Development

Post by Les Newell » Thu Apr 11, 2019 10:36 am

Set 'minimum segments for arc fitting' to 10 or set the arc fitting tolerance to 0.

luis lopez
Posts: 16
Joined: Sun Nov 24, 2013 12:44 am

Re: Problem SheetCam TNG Development

Post by luis lopez » Thu Apr 11, 2019 3:19 pm

OK
Gracias

Post Reply