Trying to use sheetcam with an older ESAB Sabre 2000

Having problems with or questions about SheetCam? Post them here.
Post Reply
NickThe1Rebel
Posts: 1
Joined: Fri Apr 05, 2019 5:24 pm

Trying to use sheetcam with an older ESAB Sabre 2000

Post by NickThe1Rebel » Fri Apr 05, 2019 6:32 pm

Hello, I am trying to make Sheetcam work with an old Esab sabre 2000 and I can't seem to get the post processor set up correctly. I am using ESAB ESSI and have it exporting in .mpg but when I put the floppy disk in the table's computer it says there's a format error and will not open the file. I'm pretty new to all of this stuff so any help would be greatly appreciated. Thank you in advance!

djreiswig
Posts: 100
Joined: Sat Feb 20, 2016 4:47 am

Re: Trying to use sheetcam with an older ESAB Sabre 2000

Post by djreiswig » Sat Apr 06, 2019 12:16 am

If you have a working gcode file that shows the proper format for your machine, you can make the post do almost anything. I'm not familiar with esab machines, so I wouldn't be much help without an example.

Post Reply