G81 Drill Routine?

If you have any problems accessing the forum or email then ask here.
Post Reply
metalfixer
Posts: 1
Joined: Sat Mar 09, 2019 2:18 pm

G81 Drill Routine?

Post by metalfixer » Sat Mar 09, 2019 2:23 pm

I have very limited knowledge in SheetCam, I can usually mill, drill and tap
and finish a part. I'm using the latest version with Mach4 on a mill.
I would like to speed things up by having the drill bit rapid travel in
the Z axis to just above the surface, and then drill at the feed rate.
Is this possible with SheetCam?
Thanks,
Larry

Post Reply