Plasma torch height problem
Posted: Fri Dec 21, 2018 3:41 pm
Hi,
I have my DIY plasma with Mach3, Proma THC150 and floating head.
My floating head switch is connected to probe. I use MP1000-THC post processor.
Floating head switch offset is set properly.
When I start cutting, head goes to pierce high and then instead to cutting hight it goes into material and after few millimeters,
THC adjust properly high.
Why is it going into material?
P.S. Sorry for my english
I have my DIY plasma with Mach3, Proma THC150 and floating head.
My floating head switch is connected to probe. I use MP1000-THC post processor.
Floating head switch offset is set properly.
When I start cutting, head goes to pierce high and then instead to cutting hight it goes into material and after few millimeters,
THC adjust properly high.
Why is it going into material?
P.S. Sorry for my english