start points in holes
Posted: Mon Sep 24, 2018 2:12 pm
Hello, i use sheetcam for plasma cutting, and when i load operations on a part with holes, they all start in
the same direction. Is there a way for a part with multiple holes, that all starting points face the center point of the part?
I use layers for holes and usually use templates for efficiency
I do that so that the plasma nozzle gets worn evenly
thank you
Richard
the same direction. Is there a way for a part with multiple holes, that all starting points face the center point of the part?
I use layers for holes and usually use templates for efficiency
I do that so that the plasma nozzle gets worn evenly
thank you
Richard