Cut from centre of circle

Having problems with or questions about SheetCam? Post them here.
Post Reply
plsmatech
Posts: 4
Joined: Sat Apr 08, 2017 6:54 am

Cut from centre of circle

Post by plsmatech » Thu Jul 12, 2018 5:59 am

Have to cut borders that consist of circles
Inner cutout then used to cut smaller border

Problem with no corners its difficult to position start of cut on middle of circle
Is there a way to tell Sheetcam to start from middle of circle and then move outward than to start in a corner

Am I missing something that are obvious

Patrick

Post Reply