arc coordination

Having problems with or questions about SheetCam? Post them here.
Post Reply
Posts: 10
Joined: Sat Feb 24, 2018 1:36 pm

arc coordination

Post by tony » Sun Jul 08, 2018 1:24 pm

I am facing a problem during arc cutting it's divide the arc on 3 points & on each point stop so it's not take it continually & for sure it cause problem
i try to change the tolerance in drawing import option but the best result i take it is with example that i send it
(1.19 KiB) Downloaded 12 times
(183.7 KiB) Downloaded 12 times

User avatar
Les Newell
Site Admin
Posts: 2110
Joined: Thu May 11, 2006 8:12 pm

Re: arc coordination

Post by Les Newell » Mon Jul 09, 2018 1:30 pm

The corners in your drawing are made up of lots of very short line segments. SheetCam tries to join them up to form an arc but it may not be doing a very good job for your application. In SheetCam go to Options->application options->drawing import and increase the arc fitting tolerance. Try something like 0.2mm (0.005"). You need to import the drawing again for this to take effect.

Post Reply