I used to know how to do this, but now I can't remember how to do it. Imagine a plaque with the letter "B". You want to make it stand out my doing a spiral fill outside the letter and again inside the 2 inside segments of the letter. I've assigned a layer name for each part.
layer name: INSIDE_letter
layer name: OUTSIDE_letter
layer name: INSIDE_plaque
And then Process > New fill > appropriate layer
Anytime I choose New fill, it fills everything including the part I want to stand out by not milling.
I am using a very old (but registered) version, but I'm not convinced that it's incapable of doing this operation.
SheetCam Version 6.2.0
Any help would be appreciated.
Having problems with or questions about SheetCam? Post them here.
1 post • Page 1 of 1