Arc to radius problem

Having problems with or questions about SheetCam? Post them here.
Post Reply
plasmaguy
Posts: 4
Joined: Tue Oct 10, 2017 4:14 pm

Arc to radius problem

Post by plasmaguy » Tue May 29, 2018 6:19 pm

Hi, when in LinuxCNC, say my plasma failed to fire and I try to make the cut again using "Run from here", I am getting a message that the arc radius is different from the start point. Is there a way to fix my issue? Thank you.

djreiswig
Posts: 64
Joined: Sat Feb 20, 2016 4:47 am

Re: Arc to radius problem

Post by djreiswig » Wed May 30, 2018 12:50 am

In Mach you have to back the code up further. I turn off dthc and start from a ways back and then manually fire the torch and turn dtch on when I get to the right place to start cutting. Assuming it is similar in Linux.

Post Reply