Request and discuss new features
- Posts: 266
- Joined: Sat Feb 01, 2014 2:07 pm
Is there a way we can have Overburn and path rules tied to each tool so when i change tool it also brings in the overturn and path rule settings?
- Site Admin
- Posts: 2054
- Joined: Thu May 11, 2006 8:12 pm
Currently there isn't any way to do this. May be able to add this if there is enough interest.
- Posts: 64
- Joined: Sat Feb 20, 2016 4:47 am
And lead in and lead out settings, too. Since they usually change with the material being cut.
- Posts: 88
- Joined: Wed Oct 23, 2013 9:50 am
One way I have been trying recently is saving a separate toolset for each material, doing that then saves each set of path rules for the material.
It's not a bad method and fairly quick to load up, don't really use overburn to be honest.