sheetcam.com

If a lead-in is selected with an open line, does sheetcam ignore the lead-in (with a "can't fit to path" error), or will it elongate the open line by the lead-in amount?

I know it will extend an open-line cut with an overcut, but now sure how it handles the lead-in/lead-out in that situation.

Thanks.

I think it would depend on the "Leadins on open paths" setting.

djreiswig wrote: ↑Sun Apr 08, 2018 7:24 pm I think it would depend on the "Leadins on open paths" setting.

Well, that's embarrassing. I never even noticed that checkbox before!

It happens to the best of us.