Page 2 of 2
Re: g-codes won't load to mach3
Posted: Sun Jan 26, 2020 9:45 pm
by Plasron
Les Newell wrote: ↑Sun Jan 14, 2018 7:26 pm
I'll send you a PM with the details.
Thanks Les
Re: g-codes won't load to mach3
Posted: Fri Apr 30, 2021 4:17 pm
by Capemonroe
I am having the same problem as Ivan. I can download art and import the dxf file into sheetcam. I can save the job BUT when I run the post processor it is not creating a valid tap file. When I try to open the G code in Mach 3 it only have a few lines of code. I have attached the job file and tap file. ANY help would be greatly appreciated. I should note that this just started and only on new downloads. It will open previously save tap files no problem. Also I do have a license with both sheetcam and mach 3. Thanks!